If your Xbox 360 controller analog stick isn’t working, you can follow these steps to repair it. To begin, first remove the thumbstick and clean it. Then, use a moist cotton swab to gently remove any sticky residue from the buttons. Dry the parts thoroughly and proceed with the next step. After cleaning the buttons, the next step is to remove the circuit board and replace the analog joystick.

The analog stick is a thin metal stick that controls the gamepad and buttons. It is the perfect size to fit the Xbox 360 controller. Taking out the old stick and replacing it with a new one is simple. Alternatively, you can take apart the Xbox 360 wireless controller to replace it with the wired one. For this step, you need to unscrew the battery case. Then, remove the six screws on the back of the Xbox 360 controller. Make sure you have the right screwdriver for the job.

Using a T8H screwdriver, remove the battery case and wiggle the metal joystick until it breaks. You can also replace the rubber joystick cover, which can be easily replaced with a new one. The next step is to remove the plastic covers. These are the green plastic covers that sit on the bottom of the Xbox 360 controller. To do this, pry out the two screws on the back of the console and remove the batteries.

Using a T8H screwdriver, unscrew the six screws on the back of the Xbox 360 controller. This step will require you to remove the battery case. To remove the screws, pull the stick upward with your fingers. To loosen the metal joystick, use a pliers. This will free up the screws. You should now be able to slide the second board onto the top of the first board.

The Xbox 360 controller has a thin metal stick, which is the analog control. To remove the stick, you need to remove the six screws. Then, use a T8H screwdriver to replace the analog stick. You may have to replace the battery. To do this, you can purchase a new one or buy another used one. Then, follow these steps to repair the Xbox 360 controller’s broken analog sticks.

Depending on the model of your Xbox 360, you may need to replace the analog stick. To do this, remove the battery case from the controller. There are six screws on the back of the controller, but only the two screws are visible. To replace the analog stick, simply take off the green plastic cover and the two screws that attach the battery. After removing the battery, you can then reassemble the controller.

To replace the analog stick, remove the battery case and take out the battery. You can use a toothpick to replace it. Place your fingers on the flat portion of the analog stick and pull up. Afterwards, break the toothpick and place it on the stick. This will replace the damaged analog stick. It is important to use the correct screwdriver for this task. It’s recommended to use a T9 screwdriver for this task.

If the analog stick on your Xbox 360 controller is broken, you should first try to replace it. To do this, you need to remove the battery case. You can either remove the battery or replace it with a new one. A new analog stick pad will give you the same experience as a replacement. You should not attempt to remove the battery if you don’t know how to do this. But if the battery is not charging, you should replace the batteries.

The analog stick on an Xbox 360 controller is made of thin metal, which is the perfect size for it. You should use a T8H screwdriver to remove the five screws holding the analog stick. To remove the battery, first pull out the rubber cover of the stick. Then, you can try wriggling the metal joystick by pulling it with your fingers. You should be able to pull it out easily.