To connect the Afterglow bluetooth headphone to your phone, turn it off and remove the charge cable. Then, look for the LED on the headset and read the instructions. Connect to Bluetooth menu. You will be asked to enter the passkey and pin. Once done, press OK to pair. The LED will blink every three seconds. Then, wait for the headset to pair with your phone.

PDP Afterglow Fener

When you first purchase a PDP Afterglow Fener Bluetooth Headset, you’ll want to read the operating instructions. These will provide you with the details you need to pair your new device with your phone. You’ll need the pin or passkey you’ve been provided, as well as a few other things. Fortunately, this process is actually quite easy. Using the instructions provided with your headset will get you started in no time.

PDP Afterglow Fener wireless headset

I’ve been looking forward to purchasing a new Bluetooth headset for my phone. Unfortunately, the only problem I’ve had with them so far is that they’ve never paired with my iPhone. Fortunately, the PDP Afterglow Fener headset has a simple setup process. To pair the headset, you simply need to plug the gray 3.5mm auxiliary cable that came with the device into the headphone jack on your phone.

If you’re having trouble connecting your new headset to your iPhone or Android device, it’s important to check the connectors. The headset’s wireless receiver may be broken. This is a relatively simple repair, but you’ll need to know some electronics to be able to fix it. If your wireless transmitter is damaged or the phone itself doesn’t have USB ports, you can try removing the speaker from the device and reconnecting the headset.

Pairing

If you’ve recently purchased an Afterglow Bluetooth headset, you’re probably wondering how to pair it with your phone. There are a few easy steps you can take, but they’ll all have the same end result: a pairing failure. First, make sure your phone has Bluetooth enabled. You can do this by locating the Bluetooth icon in the settings menu. From here, select Bluetooth settings and then click Bluetooth.

Once you have paired your Afterglow Bluetooth headset with your phone, you can move on to the next step. You must first make sure the headset is powered down and the charging cable is disconnected. The headset may also be plugged into the wrong outlet or be damaged. If this is the case, make sure you connect the headset to the phone’s Bluetooth menu and enter the passkey or pin. The LED should blink 3 times to indicate pairing.

Sound quality

The Afterglow Bluetooth headset is a lightweight wireless headphone with ample padding and an expandable strap. It pairs automatically with your phone once the transmitter is powered up. Its 50mm drivers produce clear, full-range sound with excellent low-end response. The headset’s sound quality is very good for a Bluetooth headset, and it is quite sophisticated. Afterglow also works with your phone via a 3.5mm audio jack, so you don’t have to worry about losing your headset in the process. It comes with a built-in noise cancellation feature, but I didn’t find any difference between the two modes.

Before connecting your Afterglow headset to your phone, you must power it off and disconnect the charging cable. When the headset is connected to your phone, the microphone should be pointed towards your mouth to pick up your voice. To change the audio settings, you can press the mode button on the Afterglow headset. You’ll see three different settings in this menu. The first one is “Pairing mode” while the second one is “Connecting.”